beautypg.com

2 pull type – NORAC 54VT-TJ-570 User Manual

Page 7

background image



5

3.2 Pull Type

1. Securely mount the control module (E01) inside the tractor cab.

2. Tee the CANbus interface cable (C40) in to the Tee Jet CANbus. Connect the 6 pin

Deutsch plug on cable C40 to the end of the control module with only one Deutsch
connector.

3. Connect cable C30 to the CANbus connector. Connect the other end of C30 to an

appropriate power supply.

4. Connect cable C41 to the CANbus connector and route the cable to the hitch of the

tractor. Connect the two-way coupler (E12) to the end of cable C41.

5. Connect cable C01 to the coupler (E12) and route towards the rear of the sprayer. The

two-way coupler (E12) will provide the hitch disconnect.

Figure 2: Pull Type with Control Module on Tractor Installation

See also other documents in the category NORAC Gardening equipment: