beautypg.com

3 installation, 1 canbus interface installation – NORAC 54VT-PRO-SP01 User Manual

Page 6

background image



4

3 Installation

3.1 CANbus Interface Installation

1. Securely mount the control module (E01) on the center boom at the rear of the sprayer.

2. Tee the CANbus interface cable (C40) in to the Case “Application” CANbus. The

“Application” CANbus is a 3 pin Deutsch connector located on the center section of the
boom at the rear of the sprayer.

3. Connect the Deutsch plug on cable C40 to the end of the control module with only one

Deutsch connector.

4. Connect the power cable (C30) to one of the two CANbus connectors on the control

module. Connect the 2 pin DT connector on C30 to an appropriate power source.

5. Connect cable C41 to the other CANbus connector and route the cable to the Valve

Module.

Figure 1: CANbus Interface Installation

See also other documents in the category NORAC Gardening equipment: