NORAC 54VT-PRO-PT01 - Manual (Page 6)

4
3 Installation
3.1 CANbus Interface Installation
1. Securely mount the control module (E01) at the rear of the cab.
2. Tee the CANbus interface cable (C40) in to the CANbus at the terminator behind the
ISOBUS connector. The ISOBUS connector is located on the rear of the tractor above the
drawbar. Connect the 6 pin Deutsch plug on cable C40 to the end of the control module
with only one Deutsch connector. See Section 1.3 for alternate cabling, if required.
3. Connect cable C30 to the CANbus connector. Connect the other end of C30 to an
appropriate power supply.
4. Connect cable C41 to the CANbus connector and route the cable to the hitch of the
tractor. Connect the two-way coupler (E12) to the end of cable C41.
5. Connect cable C01 to the coupler (E12) and route towards the rear of the sprayer. The
two-way coupler (E12) will provide the hitch disconnect.
Figure 1: CANbus Interface Installation