beautypg.com

3 installation, 1 control module on tractor – NORAC 54VT-GS2-PT02 User Manual

Page 6

background image



4

3 Installation

The following instructions are for installation on a trailed sprayer. On a trailed sprayer if the
CANbus and power supply are located on the sprayer, the control module may also be
installed on the sprayer (Section 3.2).

3.1 Control Module on Tractor

1. Securely mount the control module (E01) inside the tractor cab.

2. Tee the CANbus interface cable (C40) in to the John Deere CANbus. Connect the 6 pin

Deutsch plug on cable C40 to the end of the control module with only one Deutsch

connector.

3. Connect cable C30 to the CANbus connector. Connect the other end of C30 to an

appropriate power supply.

4. Connect cable C41 to the other CANbus connector and route the cable to the hitch of the

tractor. Connect the two-way coupler (E12) to the end of cable C41.

5. Connect cable C01 to the coupler (E12) and route towards the rear of the sprayer. The

two-way coupler (E12) will provide the hitch disconnect.

Figure 1: GS2 2600 Display Kit – Control Module on Tractor