NORAC 54VT-GS2-PT01 - Manual (Page 6)

4
3 Installation
The following instructions are for installation on a pull type sprayer. On a pull type sprayer if
the CANbus and power supply are located on the sprayer, the control module may also be
installed on the sprayer (Section 3.2).
3.1 Control Module on Tractor
1. Securely mount the control module (E01) inside the tractor cab.
2. Tee the CANbus interface cable (C40) in to the John Deere CANbus. Connect the 6 pin
Deutsch plug on cable C40 to the end of the control module with only one Deutsch
connector.
3. Connect cable C30 to the CANbus connector. Connect the other end of C30 to an
appropriate power supply.
4. Connect cable C41 to the CANbus connector and route the cable to the hitch of the
tractor. Connect the two-way coupler (E12) to the end of cable C41.
5. Connect cable C01 to the coupler (E12) and route towards the rear of the sprayer. The
two-way coupler (E12) will provide the hitch disconnect.
Figure 1: GS2 2600 Display Kit – Control Module on Tractor