NORAC UC5-BC-SC01 - Manual (Page 25)

21
10.2 Valve Block Mounting
1. A suitable mounting location for the valve block is illustrated in Figure 24. The
recommended location is on the horizontal cross member, above the Spray-Coupe valve
block.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 24: Valve Block Mounting