NORAC UC5-BC-MC01 - Manual (Page 23)

20
Figure 19: Valve Module Bracket Installation
5. Connect the valve module CANbus to cable C02. Route cable C02 from the other
CANbus connector to the input module.
6. With the valve module securely mounted to the valve block, connect the valve cables (C10),
to the valve coils. Insert the 2-pin plugs (P01) into the unused 2-pin connectors on the
valve module.
7. Connect the temperature probe to the valve block using the supplied 3/8” x 1/2” hex bolt.
Figure 20: Valve Module - Valve Coil Connections
Tank Port
Pressure Port
Left Tilt Ports
Right Tilt Ports