beautypg.com

8 connecting the sensors to the canbus – NORAC UC5-BC-JD10A User Manual

Page 26

background image



23

8 Connecting the Sensors to the CANbus

1. Route cable C03 from the input module to the 8-way coupler (E11). Fasten the 8-way

coupler to the boom with cable ties.

2. Connect the main lift sensor to the 8-way coupler using cable C02 and a 2-way coupler

(E12). Cable C02 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.

3. Connect the active roll sensor to the 8-way coupler using cable C03 and a 2-way coupler

(E12).

4. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing

sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.

Figure 23: UC5 Module Locations and Cable Connections

5. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.

Plug the sensor and the CANbus cable into the 2-way coupler.

6. Insert the 6-pin plugs (P03) into the unused connectors on the 8-way coupler (E11).