NORAC UC4+JD9-4B - Manual (Page 10)

7
4
ELECTRICAL INSTALLATION
Figure 6: Cable Connections
Cable C17 is the only cable
included in the kit.
1. Connect the six pin shroud (T6B) to
the mating tower on the valve extension
cable (previously installed).
2. Connect the three pin tower (T3) to
the mating tower on the valve extension
cable.
Two connectors on C17 will
remain disconnected. These are
used when installing other UC4+
options.
3. Install the two 2-pin connectors on the
end of cable C17 to the expansion
block.
The connector marked “Main
Up” goes on the port side of the
block. The port side of the block
is the side with the hose
connections.