NORAC UC4+BC+HD3 Part 1 - Manual (Page 25)

22
Figure 25: Cable Configurations: C10 and C11
Read all the following installation
instruction before connecting the
NORAC Power Cable (C10).
Ensure the UC4 Control Panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN). Use caution when
handling the 12 V power line of
the sprayer wiring.
2. Connect the UC4+ power cable (C10)
to the UC4+ Control Panel in the
sprayer cab. Ensure that both plugs
(P16A and P4) are connected to the
receptacles of the panel (Figure 25).
3. The 3-pin AMP plug (P3) on C10 is
connected to an auxiliary 12 V power
connection in the cab.
4. Route the receptacle end (R16) of C10
out of the cab.
5. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to the
free end (R16) of C10 on the outside
of the cab (Figure 25).
6. Route C11 to the rear of the sprayer,
in the vicinity of the valve block.