NORAC UC4.5-JD13 - Manual (Page 13)

10
6 Software Setup
1. Start up the sprayer and test the sprayer’s functionality. The control panel does not need
to be powered on for the original switches to function.
Confirm that the cabling and hoses are agreeable to the entire range of motion.
2. If any functions do not work, review the hydraulic and electrical portions of this manual to
check for proper installation.
3. Turn on the power for the control panel using the switch on the side of the chassis.
4. Refer to the UC4.5 Spray Height Control Operator’s Manual to run an automatic install
with the JD9 type selected.