NORAC UC4.5-BC-MC2 - Manual (Page 17)

14
Figure 13: Reference Frame Roll Sensor Mounting Location
2. Ensure the roll sensors are relatively level when the sprayer boom and chassis are level.
3. All roll sensor cables should be pointing towards the right hand wing of the sprayer when
looking from the rear of the sprayer.
4. Ensure all roll sensors are mounted adequately and that the cables provide enough slack to
allow sufficient boom roll.
6.3 Temperature Probe
Once the block is mounted, fasten the temperature probe from E03 to the NORAC valve
block using the included 3/8x1/2” bolt as illustrated in Figure 14.
Figure 14: NORAC Valve Block with Temperature Probe Installed