NORAC UC4.5-BC-HD4 Part 1 - Manual (Page 28)

25
7.2 General Installation Instructions using 44658-78
Figure 24: Cable Overview (Using 44658-78)
1. Connect the UC4.5 power cable (C10) to the UC4.5 Control Panel in the cab. Ensure that
both plugs (P16 and P4) are connected to the panel.
2. Route the P12/P6 of C10 to the exterior of the cab.
3. Connect P12/P6 to R12/R6 of the extension cable (C11). Connect at the hitch. This
connection will provide the hitch disconnect.
4. Run cable C11 from the hitch to the rear of the sprayer.
5. Connect T4, T6 and S6 of cable C11 to S4, S6 and T6 of cable C12 respectively.
6. Run the DB15 connector and the wires with the spade connectors of C12 to the DAH 09
PCB by passing it through a hole in the enclosure. Seal the hole using the weather-proof
strain relief fitting.
7. Connect the DB15 connector of cable C12 to the DAH09 DB15 connector.
8. Connect the red wire with spade connector on C12 to the Switched 12VCC on the
DAH09 board (Figure 25).
9. Connect the black wire with spade connector on C12 to the GND on the DAH09 board
(Figure 25).