Milwaukee Tool 5615-24 Wiring - Manual (Page 2)

NOTE:
All lead lengths are before stripping.
All leads must be held to ± .125"
unless specified elsewhere.
Strip wire per ES 13-11.
Crimp terminals per ES 13-15.
TERMINAL DESCRIPTION
Qty. Code Part No.
T1 23-74-0065 2
T2 23-74-1060 1
T3 23-74-0605 1
Wire Wire Origin or
No. Color Part No. Gauge Length Terminals, Connectors and End Wire Preparation
1 Black Cord 16 4-3/4" Component of cord assembly. Strip 3/16" for T1.
2 White Cord 16 4-3/4" Component of cord assembly. Strip 3/16" for T3.
3 Black 23-94-0040 18 2-1/2" Leadwire assembly. Strip 3/16" for T1 and T2.
BULK LEAD WIRE - BULLETIN 58-01-0003
WIRING SPECIFICATIONS
Remove slack
from the cord wires #1 and #2
between wire traps.
Wires are not to extend into
the frame opening.
Black cord wire #1 is
connected to the switch.
White cord wire #2 is
connected to the field
terminal as shown.
Connect T1 from the black
leadwire assembly #3 to the top
terminal on the switch. Route
#3 to the brush holder and
connect T2, as shown. Black
leadwire #3 must be placed
in the wire trap prior to the
white cord lead #2.
Order of cord wire placement
in traps are interchangeable.
Route brush shunt wires
(2 places) to brush holder,
as shown.
Cord jacket to extend past
cord clamp approx. 1/4".
Top View
WIRING SCHEMATIC
Connector Terminal (Jumper)
No. 23-74-0055
Black Black
White
FIELD
CORD ARM
SEE REVERSE SIDE FOR MODELS
WHERE WIRE #3 IS A COMPONENT
OF THE SWITCH AND IS SOLDERED
ONTO THE TOP TERMINAL.