Microtel DialStat (With Fault Indicators) - Manual (Page 21)

MICROTEL DialStat
TM
19
calling the dialer: The dialer will speak a voice message of system name and current
alarms or normal status. It will also report the current temperature and local output state
IF the local output has been manually controlled.
z System Status Gives a complete status of all points monitored by the dialer
*00 Report system status
Example- Command:
*00
Response: MICROTEL DIALSTAT Channel one normally closed
digital input in alarm. Temperature is seven eight degrees.
The local output is open.
Controlling the local output relay
DialStat
TM
has a set of output contacts that may be controlled from a touch-tone phone.
These contacts may be used to turn ON or OFF external equipment, or as a signal input to
another device. Simply enter the following command during a phone call to or from the
dialer, via either the phone or cellular connection.
NOTE: de-energized state is open.
*06
Review local output configuration
**06 0/1/2 Configure/Control local output
Example- Command: **060
Response: The local output is closed.
Example- Command: **061
Response: The local output is open.
Example- Command: **062
Response: The local output is fault status