Microtel CellStat v.1.10 - Manual (Page 21)

MICROTEL CellStat
TM
19
Response: Power fault channel is READY
Command: **530
Response: Power fault channel is OFF
Telephone Numbers
As described in the theory of operation in Chapter 1, CellStat
TM
can store up to eight (8)
phone numbers in the System Telephone Directory. This section explains how to
program the dialer’s telephone numbers and shows how to customize the numbers for
certain call-out situations.
Use the following command to enter each telephone number into CellStat
TM
:
*6n
Review Telephone n (n=1 to 8)
**6np** Program Telephone n (n=1 to 8)
p = telephone number of up to 30 digits with escape codes for one of 8 (eight) telephone
numbers. The telephone data is terminated with ‘**’ (two asterisks).
Example- Command:
**61 2760571**
Response: Telephone number one is two seven six zero five
seven one.
Phone number dialing may be customized on a number-by-number basis. Refer to the
Advanced Topics chapter for using the powerful features of the CellStat
TM
Dialer.
Setting the Email Address
CellStat
TM
has the capability to store a single user email address. Upon a new alarm
detection, CellStat
TM
can wirelessly transmit an email alert to this address via its built-in
cellular capability before it begins calling the phone numbers on its list. This capability
provides the benefit of an electronic record of each and every alarm event that occurs.
Email alerts are only sent via the built-in cellular capability, not over the telephone line.
The email address is configured into the dialer by sending the following SMS text
message from a mobile phone to CellStat
TM
’s cellular phone number:
“set email ” Set the email address via SMS Text Message
“email” Query the current email address via SMS Text Message
Example- Command: “set email [email protected]”
Response: None