Microtel CellStat v.1.10 - Manual (Page 19)

MICROTEL CellStat
TM
17
z Answer Delay The number of rings the dialer will see before answering an incoming
call on the telephone line. NOTE: Incoming calls on the cellular interface are
answered after 1 to 3 rings.
*02 Review
answer delay
**02nn Program answer delay
Example- Command:
**0205
Response: The telephone answer delay is zero five rings.
z Access Code This 2 digit access code is required to access configuration commands
during a telephone call to or from the dialer.
*03 Review value of access code
**03nn Program access code
NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable
access code requirement. Access code is not required to configure the dialer through
the local PHONE jack.
Example- Command:
**0313
Response: The access code is one three.
z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-
arm an acknowledged alarm and begin calling again as a reminder that the alarm
condition still exists.
*04
Review snooze delay time interval
**04HH Program snooze delay time interval
Example- Command:
**0412
Response: The snooze delay is one two hours.
z Firmware Version
*05 Report
Firmware Version
Response will play back all resident vocabulary, then speak “Cell Stat number one
zero”, where “one zero” is the current Firmware version (e.g. 1.0).
Configuring Fault Inputs