Make Noise FXDf User Manual
Page 3
INSTAllaTIon
The Make Noise FXDf is an electronic signal processor requiring 27mA of +12VDC and
27mA of -12VDC regulated power and a properly formatted distribution receptacle to
operate. It is designed to be used within the euro format modular synthesizer system.
Go to
http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 4 HP of space in your euro-rack synthesizer system, confirm proper
installation of included power cable on backside of module (see picture below), plug
the 16 pin end power cable into the euro-rack style power distribution board,
minding the polarity so that the RED stripe on the cable is oriented to the NEGATIVE
12 volt supply line. On the Make Noise power bus board, the negative 12 volt supply is
indicated by the white stripe.
s’
Please refer to your case manufacturer specifications for location of the negative supply