Channel Plus MDS-6 - Manual (Page 4)

Page 1
B C
TM 120V 50/60Hz 300W
Multiplex Technology Inc.
MADE IN CHINA DESIGNED IN
USA
MODEL MDS-6
MULTI-ZONE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.
WARNING: SHOCK HAZARD - DO NOT OPEN.
IR REMOTE OUTPUTS
1
SOURCE OUTPUT
PAGE
A B
DOORBELL STATUS
S G +5v G +5v G
AUDIO
INPUT
SWITCH
INPUT
UNIT
ON
TRIG
ON
IN OUT
SOURCE 1
IN OUT
SOURCE 2
IN OUT
SOURCE 3
IN OUT
SOURCE 4
IN OUT
SOURCE 5
IN OUT
SOURCE 6
INPUT SOURCES ZONE CONTROLLERS
1 8
OUT
L
R
ZONE 1
L R LEFT
- + RIGHT - +
ZONE 2
L R LEFT
- + RIGHT - +
ZONE 3
L R LEFT
- + RIGHT - +
ZONE 4
L R LEFT
- + RIGHT - +
ZONE 5
L R LEFT
- + RIGHT - +
ZONE 6
L R LEFT
- + RIGHT - +
LINE OUT / SPEAKER OUT
20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 20W/8 OHM X2 LINE OUT LINE OUT LINE OUT LINE OUT LINE OUT LINE OUT
SUM OUTPUT 1 8 1 8 1 8 1 8 1 8 1 8 1 8
IN 1 2 3 4 5 6
MASTER INDIVIDUAL ZONES
A
2
B
3
C
4
D
MDS-6 Music Distribution System
Active On
TM
G H I F E D
Power
A
D.) Output Section - This section is the output section. It provides the speaker terminals and line
outputs.
E.) Distribution Section - This section is the line level input/output section. It provides the inputs from
your sources and the outputs for stacking additional units.
F.) Controller Section - This section is where the wall controller in each zone connect. This section
includes the “party” mode master controller input.
G.) Paging/Control Voltage Section - This section is the paging and control voltage input and output
section. It provides the inputs from your phone system and door bells (front and back). It also has a
control voltage input and output for the unit controlling or being controlled by additional equipment.
H.) Infrared (IR) Section - This is the IR section. It provides outputs for the IR emitters.
I.) AC Power Cord - This is where the AC power cord connects to the unit. It is a detachable 3 prong
I.E.C. plug.
A.) Power Switch - Left on, the MDS-6, when not being used, will go into a “sleep” mode, ready to
turn back on when an input signal is applied from any of the six sources. In the off position, the unit
will not function.
B.) On LED - With the power switch on, this LED indicates that the unit is powered up and “awake”.
C.) Standby LED - This LED indicates that the unit is plugged into the wall.