Longshine LCS-844MT - Manual (Page 41)

37
ping:
Type ping followed by a space, and then
the IP address of the device to send a test
signal. If a response is received, then the
device is connected. To view a full list of
ping options, type ping and press ENTER.
reset:
Type reset config and press ENTER to
load factory default settings, or type reset
system and press ENTER to restart the
system.
show:
Type show to display variety of device
server settings.
set:
To configure the management settings, type
the commands below, followed by the
ENTER key.
NOTE: Separate each port of the command line
with a space.
set admin - follow the prompts to change user name
and password
set eth0 - the command is for factory setting use set
eth0 ip (new IP address) network mask
(new network mask) gateway
(new
gateway). Use this command to set new
Ethernet settings.