Installation – Liberty Garden 710 User Manual
Page 3
3
INSTALLATION
1
2
NOTE: The following hardware (not included)
is recommended for installation.
NOTE: The following hardware (not included)
is recommended for installation.
•
Position and hold your Navigator base shelf (C) against
the brick masonry wall at a convenient height. Mark the
position of each suspension hole on the wall. Remove the
base shelf (C).
•
Using a power drill, drill holes 9/16” in diameter and
1 5/8” deep at the marked positions on the wall.
•
Insert the masonry wall anchors into the anchor sleeve.
Next, insert the anchor and sleeve into the drilled holes
until the steel sleeve is completely in the wall.
•
Place the base shelf (C) on the masonry wall anchors.
•
Install a washer, lock washer, and nut over each wall
anchor and tighten securely.
•
Position and hold your Navigator hose reel base shelf
(C) against the wood wall at a convenient height. Mark
the position of each suspension hole on the wall.
Remove the base shelf (C).
•
Using a power drill, drill pilot holes 1/4” in diameter and
2 1/2” deep at the marked positions on the wall.
•
Align the hose reel suspension holes with the pilot
holes.
•
Attach the base shelf (C) to the wall using the lag
screws with washers and tighten securely.
MOUNTING ON BRICK MASONRY WALL
MOUNTING ON FLAT WOOD FRAME WALL
(4) 7 or 8 mm x 60 mm masonry wall anchors
(5/16” x 2 1/2”)
(4) Anchor sleeves
(4) Washers
(4) Lock washers
(4) Nuts
(4) 7 or 8 mm lag screws with washers
(5/16” x 2 1/2”)
This hose reel must be mounted to a solid masonry wall or to wall studs
C
Mounting Hole
Size: 10mm
Mounting Hole
Size: 10mm
TIP: Remember to use the correct size and quantity of hardware to properly support the
total weight of the unit. A standard 100' length of garden hose weighs approximately 15 lbs.
Filled with water the additional weight can exceed 20 lbs. The mounting hardware must be
able to support the combined weight of the unit, garden hose, plus water.
C