LEWITT DGT 650 - Manual (Page 10)

10
// Operating the microphone
The following will walk you through all the settings of your DGT 650.
Standard Mode // This is the default state of the device when you power it on ( is illuminated white).
Settings Mode // This is where you can change all the settings on your DGT 650 including recording modes,
monitoring options, high-pass filters, pre-attenuation and gain. The illuminated LEWITT logo will turn off as
soon as the microphone switches to Settings Mode. Press the jog dial
to switch from setting to setting and
rotate it to change the selected setting.
headphone/Output gain // The headphone symbol is lit. Rotate the jog dial to change the output volume.
ATTENTION : Your DGT 650 has a professional, built-in headphone amp. Be sure to check your gain settings
befor using headphones, the signal can be very loud. Honestly, we mean it - this can seriously harm your ears.
Input gain // Press the jog dial until the input gain symbol is lit. We use a very fine gain control – there are
intermediate steps that do not show up on the LEDs. The settings will change depending on the selected
recording mode. You can set input gain levels for all 4 recording modes individually.
Stereo Mode selected // Gain L R will be lit. Rotate the jog dial to change the gain for both capsules
together.