Leslie Controls Temperature Fixed and Adjustable Proportional band type - Manual (Page 2)

2
INTRODUCTION
This Installation, Operation, and Maintenance Manual is
intended to be as complete and up to date as possible. It
covers installation, operation, and maintenance procedures
for Leslie Controls, Inc. Temperature Fixed and Adjustable
Proportional Band Types. Leslie reserves right to update
this manual and other product information concerning
installation, operation, and/or maintenance, at any time and
without obligation to notify product owners of such
changes.
Leslie is not responsible for injury to personnel or product
damage due to improper installation, operation, and/or
maintenance Leslie Controls, Inc. Temperature Fixed and
Adjustable Proportional Band Types. All installation,
operation, and maintenance procedures should only be
performed by trained/certified personnel. All personnel
performing these procedures should completely and
carefully read and understand all supplied materials before
attempting procedures. All personnel should pay strict
attention to all Notes, Cautions, and Warnings that appear
within procedures detailed in this manual.
Leslie welcomes user input as to suggestions for product or
manual improvement.
Contact Information
For information concerning warranties, or for questions
pertaining to installation,
Operation or maintenance of LESLIE products, contact:
LESLIE CONTROLS INC.
12501 Telecom Drive
Tampa, FL 33637
USA Phone: (813) 978-1000
USA Fax: (813) 978-0984
www.LESLIECONTROLS.com
To order replacement parts, contact LESLIE CONTROLS
at address listed above, or call toll free:
USA/Canada/Caribbean Phone: (800) 323-8366
Note: Please include model and serial number of unit for
which parts are being ordered. If ordering by phone, please
have this information readily available.
GENERAL NOTES AND WARNINGS
Notes:
•
If questions are not answered by this manual, or if
specific installation, operation, and/or -
maintenance procedures are not clearly
understood, contact Leslie Controls, Inc. for
clarification before proceeding.
•
If unit is damaged during installation, operation,
or maintenance, complete following steps:
1. Turn off and lock out pneumatic supply to unit in
an approved manner.
2. Turn off all incoming valves.
3. Contact in-house maintenance personnel or Leslie
Controls, Inc. for instructions.
Note: Throughout this manual, warnings will be
denoted by BOXES
It is strongly recommended that this document be reviewed
before attempting any installation, operation, or
maintenance procedures.
CAUTION!
Piping system must be adequately designed and
supported to prevent extraordinary loads to pressure
equipment.