LABEC J-USRC - Manual (Page 6)

Input Power
Use the product with the specified input power voltage.
For applying power, use the AC power cable provided. The shape of the plug differs
according to the power voltage and areas. Use the cable, which is suitable for the line
voltage used.
Fuse
With products with a fuse holder on the exterior surface, the fuse can be replaced with
a new one.
When replacing a fuse use the one, which has appropriate shape, ratings, and
specifications.
Cover
There are parts inside the product, which may cause physical hazards. Do not remove
the external cover. If the cover must be removed, contact your LABORATORY
EQUIPMENT PTY LTD agent in advance.
Installation
When installing product be sure to observe Installation Precautions described in this
manual.
To avoid electrical shock connect the protective ground terminal to electrical ground
(safety ground).
When applying power to the products from a switchboard, be sure work is performed
by a qualified and licensed electrician or is conducted under the direction of such a
person.
Be sure to use the AC power cable provided.
Relocation
Turn off the power switch and then disconnect all cables when relocating the product.
Use two or more persons when relocating a product which weights more than 20kg.
The weight of the product can be found on the rear panel of the product and/or in this
operation manual.
Use extra precautions such as using more people when relocating into or out of
present locations including inclines or steps. Also handle carefully when relocating tall
products as they can fall over easily.
Be sure the operation manual is included if the product is relocate.
Maintenance
To avoid electrical shock, be absolutely sure to unplug the AC power cable or stop
applying power before performing maintenance or checking.
Do not remove the cover when performing maintenance or checking. If the cover must
be removed contact your LABORATORY EQUIPMENT PTY LTD agent in advance.
To maintain performance and safe operation of the product, it is recommended that
periodic maintenance, checking, cleaning, and calibration be performed.
Service
Internal service is to be done by LABORATORY EQUPMENT PTY LTD service
engineers.
If the product must be adjusted or repaired contact your LABORATORY EQUIPMENT
PTY LTD agent.
1. Intended use of the apparatus.
Laboratory shakers are used in biological experiments to blend or agitate samples within flasks or
tubes. This model is designed for culturing microbes and further for culturing, mixing, extracting
and manipulating microbiological and plant tissues.
Our shaker model has an agitation platform attached. The platform has simple flask clamps
Laboratory Equipment Pty Ltd – Operation Manual J­USRC Shaker Page 6