LABEC SS2 - Manual (Page 4)

POTASSIUM
HYPOCHLORITE SULPHUROUS
SODIUM CHLORIDE TARTARIC
SODIUM
HYPOCHLORITE
Operation
1.
Connect the steriliser to an alternating current supply of voltage specified on the rating plate.
DANGER: THIS STEAM STERILISER MUST NOT BE CONNECTED TO A DIRECT POWER SUPPLY
2.
Turn the simmerstat up as required and switch the MAINS on and check the indicating lamp
is illuminated.
3. An indicating lamp next to the simmerstat will illuminate when the heaters are operating.
Maintenance
The cabinet is finished with stainless steel and to maintain appearance should be wiped over with a
non abrasive cleanser.
The interior is also stainless steel and may be cleaned with a solvent.
The false bottom can be removed to allow cleaning around the element and controller sensor.
A fixed gabled lid is fitted and the hinge on the back should be kept clean and free from foreign
objects to maintain easy opening.
Troubleshooting
SYMPTON REMEDY
No Power
(Indicator Light is off)
1. Check steriliser is plugged in and power
switched on.
2. Ensure mains power supply point is
functioning by using a test appliance on
power socket.
3. Check internal RCD has not tripped.
Failure to heat or maintain temperature
(Indicator light is on) 1. Ensure simmerstat is turned on
2. Ensure the manual reset button is
depressed.
If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the
steam steriliser from the manufacturers label.
Declaration of Conformity
Each product is thoroughly inspected and tested to not only ensure that it meets the specifications
provided, but to also meet Australian Electrical Standard AS3820 and EMC Standard
AS/NZ1044:1995,and therefore being accredited with a C Tick label.
3 Laboratory Equipment Pty Ltd Instruction Manual – Steam Steriliser 2013 ver 1.0