LABEC SS2 - Manual (Page 2)

Introduction
Congratulations on the choice of an Australian made quality product. Labec products are
manufactured, tested and calibrated to meet published standard specifications under our strict quality
assurance guidelines.
This Instruction Manual is for the guidance of operators of Labec Steam Steriliser and should be read
before the Steriliser is connected to the electricity supply.
It is hoped that this manual will supply all the information that the customer should require for
satisfactory operation of the Steriliser. If, however, there are any questions that remain unanswered
then the customer should contact our Service Department.
Unpacking
Remove all packing and protective wrapping from both interior and exterior of the steam steriliser.
Check the steam steriliser for any possible transit damage. Ensure all ordered accessories are
present. If any physical damage or shortages are evident, do not discard the packaging material until
the steam steriliser is inspected by the distributor, agent or manufacturer.
NOTE: All claims for shortage or damage must be made within fourteen days (14) from delivery.
Subject to our standard published conditions of sale, we have reasonable grounds to believe that we
have ensured, so far as is reasonably practical, that the products listed in our catalogue and
brochures have been designed and constructed so as to be safe and without risk to health when
properly installed and used in their environment by appropriate and trained personnel, and where
applicable, in accordance with our published instructions.
Installation
Electrical
This equipment must be tagged and tested according to AS/NZS3760:2010 prior to use and
thereafter every 6 months dependent upon the environment.
It is preferable to locate the steam steriliser close to a power point and recommended that double
adaptors are not used. Check the total wattage if connecting to multipoint outlets. Check the rating
plate for power requirements. Installation is to be carried out by a qualified electrician in accordance
with the power requirements of the product specifications.
Location
Select a location free from draught and away from direct sunlight or other heat source.
Heating
Heating of the steriliser is by means of inconel elements located in water at the base of the steriliser.
Description of Controls
Set the heating level on the simmerstat by turning the knob clockwise, a heater light will illuminate
when power is being supplied to the elements.
Safety Cut Out
If the steam steriliser is fitted with a manual reset button, be sure this is depressed before use. If the
water level is too low or runs out the switch will pop out and turn the heaters off until the reset is
depressed.
1 Laboratory Equipment Pty Ltd Instruction Manual – Steam Steriliser 2013 ver 1.0