LAARS Mighty Venter MV5 (Sizes 500-1825) - Install and Operating Manual - Manual (Page 7)

Mighty Venter Power Vent Systems
Page 7
Figure 4. Placement of plumber's strap or threaded rod for MV4 and MV5.
Figure 3. Placement of plumber's strap or threaded rod for MV3.
Plumber's Strap or Threaded Rod
Plumber's Strap or Threaded Rod
3b. Power Venter Mounting
The installer must supply plumber's strap or 1/4
threaded rod with nuts and washers for mounting (see
Figure 3 for MV3, see Figure 4 for MV4 and MV5).
The Mighty Venter may be mounted in any position as
long as the shaft of the motor remains horizontal. The
Mighty Venter housing is single wall, 6 inches
(152mm) must be maintained from all combustible
materials. It is recommended that the Power Venter
be mounted as close as possible to the point
of termination.
Horizontal
Installation
Vertical
Installation
Horizontal
Installation
Vertical
Installation