Kuzma Stabi - Manual (Page 15)

_________________________________________________________________
S T A B I T U R N T A B L E 15 KUZMA
iv) With large screwdriver release screws at points A and B and catch cable
between
wood and screw washers.
v) Between these two points the cable should be free and touch nothing. The cable
must be long enough to allow subchassis movement but not too long. To check
this replace leg on worktable so you can inspect the position of cable. If
necessary
reposition with fingers.
vi) If position is not satisfactory release cable at point B and lengthen or shorten as
required.
vii) Check subchassis movement by pressing spindle when platter should oscillate
for a few seconds.