Keri Systems Time and Attendance - Manual (Page 2)

Time and Attendance
2305 Bering Drive 01943-001 Rev. B
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 2 of 4
Application Note
PXL-500 / PXL-510
1.0 Wiring
The wiring of a Time and Attendance Terminal is exactly the same as for any PXL-500. All wiring
diagrams and instructions may be found in the PXL-500/PXL-510 Quick Start Guide (P/N 01918-
001) and SB-593 Satellite Board Quick Start Guide (P/N 01925-001). Time and Attendance
Terminals ordered with a reader come with the reader pre-wired.
2.0 Setup in Doors
The Time and Attendance Terminal must be configured in Doors. The following steps must be
completed in order for the controller to act as a Time and Attendance Terminal.
2.1 Enable Time and Attendance Control
The door type parameter allows an operator to enable the Time and Attendance Terminal control
features of the Doors program. When the Time and Attendance Terminal control feature is enabled,
the Doors program makes several minor changes to support the feature.
• A Door Type column is added to the System
 Setup Doors tab allowing a specific door to be
identified as a Time and Attendance Terminal.
• The standard icon for doors, viewed as , changes to appear as for doors identified as a
Time and Attendance Terminal when creating Access Groups or when performing manual door
control.
1. From the System Options tab, click on the button. The System Options
window will reveal the Door Type field where selections may be made for door type control
(see Figure 1-1 on page 3).