Keri Systems TRB - Manual (Page 3)

Tamper Relay Board
Installation Guide
Page 3 of 3 P/N: 01513-001 Rev. D
NXT Tamper Event Report Connection
•
allows the NXT controller to record an Enclosure Tamper event
• connect the provided cable between J2 on the TRB and J1 on the NXT controller – this is a keyed
connection so be sure to orient the plug correctly
NOTE: The Tamper Event Report connection does not apply to the PXL. The PXL does not have the
ability to report Enclosure Tamper events.
4.0 Unit Operation
The TRB is operational as long as power is supplied to the unit. Two LEDs on the TRB provide unit
status.
• Red LED – indicates alarm condition
• Green LED – indicates non-alarm condition
Verify tamper switch operation by toggling the tamper switch(es) and observing the red and green
LEDs follow tamper switch state.
Contact Keri Systems:
End of document.
Keri USA Keri UK, Ireland, Europe
2305 Bering Drive
San Jose, CA 95131 Unit 17
Park Farm Industrial Estate
Ermine Street
Buntingford
Herts SG9 9AZ UK
Telephone: (800) 260-5265
(408) 435-8400 Telephone: + 44 (0) 1763 273 243
Fax: (408) 577-1792 Fax: + 44 (0) 1763 274 106
Web: www.kerisys.com Web: www.kerisystems.co.uk
E-mail: [email protected]
[email protected] E-mail: [email protected]
[email protected]