Kenton Poly(supplied prior to mid 1990) - Manual

INSTRUCTIONS FOR MIDI INTERFACE
FOR EARLY POLY SYNTH RETROFITS - fitted before approx June 1990
MIDI - - -
First - a few words about Midi. Midi is an acronym of Musical
Instrument Digital Interface. It is a system for transferring
information between synths or other equipment. The information is
sent in digital format using codes laid down by the international
Midi committee.
USING THE INTERFACE - - -
When you first turn on the synthesiser you will be in what is called
omni on - poly mode. What this means in effect is that the interface
is listening on all the Midi channels at once, and will respond to
information on any of them. You can switch to omni off - poly mode by
using the program mode push button and selecting a receive channel.
What this means is that you can set the interface to respond to Midi
information in one channel only.
MODE CHANGE PUSH BUTTON
This push button has several functions :-
1) Pressing once only enters patch change mode. Any key then selects
a patch change which it sends through midi.You are then automatically
returned to playing mode.
2) Pressing twice enters program mode. This enables you to program
in such things as receive / transmit channel number information etc.
Once you have entered program mode, the interface will stay in that
mode until top C on the keyboard is pressed, and until that time, any
key pressed will change a parameter.
On the following page is a list of what each key will do if
pressed during program mode.
3) Pressing once and holding for a couple of seconds enters transpose
mode. You will know this has happened because middle C will sound,
and continue to do so until you press another key. You are then
returned to playing mode.
The note you press will be the new middle C via midi in
Transpose mode cannot be entered from program mode.
WHEN NOT USING MIDI IN - ENSURE THAT VCF/VCA SWITCHES ARE TURNED OFF