Kenton Taurus Bass Pedals - Manual

KENTON electronics
INSTRUCTIONS FOR MIDI INTERFACE
MOOG TAURUS BASS PEDALS
USING THE MIDI INTERFACE
When you select a receive channel or other set-up, this will be stored in memory and will be remembered for when
you subsequently turn on the pedals - all parameters listed on the next page are stored.
If you want to put the machine back to the factory default settings at any time, switch the synth on whilst holding
the red push button pressed - hold for a couple of seconds then release.
SETTING MIDI TRANSMIT AND RECEIVE CHANNELS
Give the red push button a short press (half a second) - then release. Follow this with a press of a bass pedal -
Bottom C will set channel 1 and top C will set channel 13 (See list below) - The selected channel will be stored in
memory and recalled when the unit is next turned on.
If you want to put the machine back to the factory default setting at any time, switch the pedals on whilst holding
the red push button pressed - hold for a couple of seconds then release. See next page for factory default
settings.
RED PUSH BUTTON
Before you press the red button, make sure that no notes are pressed on the pedals otherwise the results may be
unpredictable.
SET-UP MODE
Setting MIDI channels and assignments. Give the red push button one short press (half a second) - then release.
Follow this with a note or sequence of notes as detailed on page 2. After selecting a channel you will be
automatically returned to playing mode but after making assignments you will need to press the ENTER key (Top
C) to return to playing mode. This is to enable you to make the multiple key presses required when re-assigning
sources to destinations. (N.B. set-ups are stored in non volatile memory).
C Transmit / Receive channel 1 (factory default)
Db " " 2