Crate Amplifiers POWER BLOCK CPB150 - Manual (Page 8)

CPB150 TECHNICAL SPECIFICATIONS:
Output Power Rating Mono 150W RMS @ 10% THD @ 8 ohms
Stereo 75W RMS @ 10% THD per side @ 4 ohms
Input Impedance Instrument 700k ohm
CD 22k ohm
Line In 22k ohm
Total System Gain (all controls @10)
Instrument 91dB
CD 33dB
Line 34dB
Maximum Input Signal Accepted 8 volts peak to peak
Tone Controls Low 20dB range @ 110Hz
Mid 15dB range @ 1kHz
High 20dB range @ 10kHz
Power Requirements 120 VAC, 60Hz, 35VA
100/115VAC, 50/60Hz, 35VA
230VAC, 50/60Hz, 35VA
Dimensions 3.2” H x 10” W x 5.6” D
Weight 4.6 lbs.
The CPB150 is housed in an anodized aluminum chassis: occasionally wipe it clean with a lint-free cloth.
Never spray cleaning agents onto the unit. Avoid abrasive cleansers which would damage the finish.
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications
and information in this manual are subject to change without notice.
www.crateamps.com
@2005 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133
47-463-02 • 061305
CPB150 PowerBlock
150 Watt Stereo Guitar Amplifier
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this device not expressly approved by SLM Electronics could void the user’s
authority to operate the equipment under FCC rules.