Kenton Minimoog - Manual (Page 3)

ASSIGNING MIDI CONTROLLERS
1) To assign MIDI controllers for the controllers available on page 2:
a) press the red push button to enter set-up mode (short press and release)
b) send the controller you want to assign by moving the knob or slider on your controller (e.g. cc#20)
c) press a key on your remote keyboard to select the item you want to control with it (e.g. MIDI LFO speed)
d) either hit Top C to enter/exit and store, or go back to b to assign another controller to an item.
2) If you use a controller (such as MIDI LFO speed) - the value set can be stored by entering and then exiting setup
mode – in other words, give the red push button a short press, then press top C to exit. All changes made will be
stored.
3) Receive channel setting will return you directly to playing mode, all other keys will let you stay in SET-UP mode
until you press the ENTER key (Top C).
4) The ENTER key (Top C) also performs a “reset all controllers” function – OFF in most cases, but ON for volume,
and centre for pitch bender.
5) If you want to put the MIDI back to the default settings at any time, switch the Minimoog on whilst holding the red
push button pressed – hold for a couple of seconds then release.
6) During set-up mode, the retrofit will receive on ALL MIDI channels.