Kenton GPIM-16 - Manual (Page 4)

4
FACTORY DEFAULTS
If you want to reset your GPIM-16 to its factory default settings, you can do so by applying power to the
unit whilst holding the recessed edit button pressed.
`def` (factory defaults) will momentarily be displayed when this has been done.
The factory default settings are:
MIDI channel #1
GPI 1-8 midi notes 36-43,
GPI 1-8 MIDI off enabled (yes)
GPI 9-16 midi notes 44-51
GPI 1-8 MIDI off enabled (yes)
Debounce time 5mS
Output message type=notes
DISPLAYING THE FIRMWARE VERSION NUMBER
Power the unit on while holding the ‘dec’ button pressed – keep pressed while you read the number.
When you release the button you will be in analyser mode. Pressing all three buttons mode, dec and
inc together will exit analyser mode and return the unit to normal operation.
SPECIFICATIONS
Power Input 9V DC – mains adaptor supplied
Power consumption
100mA, 2.1mm plug (centre positive)
MIDI
In, Out1 & Out2 (out1 & out2 give the same data out)
Inputs
16 GPI – 8 on each of 2 x 9 pin D connectors – pin 9 common ground
Display
3 x 7 segment display
Weight
850 gms including PSU
Dimensions
190 x 110 x 38 mm
Non-volatile memory
EEPROM (no back-up battery required)
WARRANTY
The GPIM-16 comes with a 12 month (from purchase date) back to base warranty, (i.e. customer must
arrange and pay for carriage to and from Kenton Electronics).
Brookfarm House, 1 Station Road, South Wimbledon, London, SW19 2LP, UK
Tel: +44 (0)20 8544 9200 Fax: +44 (0)20 8544 9300
[email protected] www.kenton.co.uk
firmware rev# 1138 e. & o. e.  21 st February 2008