beautypg.com

Fcc rf exposure information and statement – Verykool s635 User Manual

Page 22

background image

l

check if you set call barring, if yes, cancel it

Screen is dark

l

check if battery is low, change a battery or charge the battery

l

adjust the brightness in settings

l

Your phone may be affected with damp, keep it dry.

Tips: if all suggests and solutions can’t solve your problem, please contact authorized after
service center. Please do not disassembly or repair your phone without professional guide.

FCC RF Exposure Information and Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types

S635

(FCC ID: WA6S635) has also been tested against this SAR limit. The highest SAR value

reported under this standard during product certification for use at the ear is 0.718W/kg and

when properly worn on the body is

0.727W/kg. This device was tested for typical body-worn

operations with the back of the handset kept 1.5cm from the body. To maintain compliance with

FCC RF exposure requirements, use accessories that maintain a 1.5cm separation distance

between the

user's body and the back of the handset. The use of belt clips, holsters and similar accessories

should not contain metallic components in its assembly. The use of accessories that do not

satisfy these requirements may not comply with FCC RF exposure requirements, and should

be avoided.

FCC WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

22