Philips QT4050-41 - Manual (Page 8)

n Make sure the Trimmer is turned OFF and
disconnected from the electrical outlet.
B Remove the trimming comb (fig. 8).
B Remove the cutting unit (fig. 12).
□ Clean the cutting unit and the inside of the
Trimmer with the brush supplied (fig. 13).
B Put the cutting unit and the trimming
comb back onto the Trimmer (fig. 14).
Trimmer
Replacing The Cutting Unit
If your cutters and filter become damaged or
worn, do not continue using the Trimmer Replace
cutters and/or filter immediately.
This Trimmer has no other user-serviceable parts.
For assistance call I -800-243-3050.
Assistance
For Assistance, call toll free:
1-800-243-3050
or visit our website: www.philips.com/
support
Information is available 24 hours a day, 7 days a
week.
Storage
i Be sure Trimmer is turned off and remove cord
from outlet and Trimmer before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
I Do not wrap cord around Trimmer when
storing.
i Store Cord in a safe location where it will not
be cut or damaged.
I Do not place or store Trimmer where it can
fall or be pulled into a tub or sink, water or
other liquid.
Battery Removal
I This Philips Norelco Trimmer contains a
rechargeable Lithium-Ion battery
which must be disposed of properly (fig. 15).
I Battery should only be removed when
Trimmer is to be discarded.
I For assistance, call toll free: 1-800-243-3050 or
visit our website: www.philips.com/norelco.
B Unplug electrical cord from outlet and
Trimmer before dismantling Trimmer.
B
Allow the Trimmer to run until the battery is
empty/depleted.
B
Turn Trimmer OFF.
Q Open the lid of the hair collection
chamber (fig. 9).
B
Remove the 4 screws inside the hair chamber
with a screwdriver (fig. 16).
□ Pull the hair-collection chamber out of the
appliance with some force (fig. 17).
B
To remove the front panel, wedge a
screwdriver between the front panel and
the inside of the appliance (fig. 18).
B Remove the 4 screws on the inside of the
appliance (fig. 19).
□ Remove the inner panel (fig. 20).
[Q Remove the printed circuit board with the
rechargeable battery connected to it (fig. 21).
m Cut the wires between the printed circuit
board and the rechargeable battery.
m Do not attempt to replace battery. Insulate
battery ends by covering with tape and/or
place battery in a small plastic bag.
\E
Discard your Trimmer. Do not attempt to
plug electrical cord into the outlet or
recharge the Trimmer after the battery has
been removed.
\E
Contact your local town or city officials for
battery disposal information or call
I-800-8-BATTERY or www.rbrc.com for
battery drop-off locations.