Philips QT4050-41 - Manual (Page 5)

Trimming
ft Use this Trimmer for its intended household
use as described in this manual,
ft Always comb your beard and/or moustache
with a fine comb before you start trimming,
ft If you are trimming for the first time, be
careful. Do not move the Trimmer too fast.
Make smooth and gentle movements,
ft After trimming, residual hair length can vary
depending on hair type.
Trimming With Trimming Comb
ft The hair length settings are indicated in
millimeters on the trimming comb.The settings
correspond to the remaining hair length after
trimming.
ft The trimming comb cuts hair to a length of
1-18 millimeters/1/32 - 23/32in.
ft The trimming comb must be on Trimmer
in order to use the Zoom Lock.
U Slide the trimming comb onto the Trimmer
(fig- 3).
Q Turn the Zoom Lock (fig. 4) to the desired
hair trimming length setting (see table).The
selected hair length setting is indicated by
the arrow on the side of the Trimmer (fig. 5).
ft If you are trimming for the first time, start by
using the maximum trimming length setting of
l8mm/23/32 in. to prevent accidentally
trimming hairs too short. As you become
familiar with the settings, adjust Zoom Lock
to desired trimming length.
H Turn the Trimmer ON (fig. 2).
□ To trim in the most effective way, move the
Trimmer against the direction of hair growth.
Do not move the trimmer too fast. Make
smooth and gentle movements and make
sure the surface of the trimming comb always
stays in contact with the skin (fig. 6).
NOTE: Since all hairs do not grow in the same
direction, you may want to try different trimming
positions (i.e.. upwards, downwards, or across).
Practice is best for optimum results.
H Turn the Trimmer OFF.
□ Clean the Trimmer (see section ‘Cleaning’).
Trimming Length Settings Table
Hair Length (mm) Hair Length (in.)
1 Stubble Length 1/32
3 1/8
6 1/4
9 3/8
12 15/32
15 5/8
18 23/32