Coleman 3000 WATT Power Inverter User Manual

Page 5

PMP3000 Models

Modelos PMP3000

Owner’s Manual

Manual del Usuario

Reason

Solution

Poor contact with

Clean terminals

battery terminals.

thoroughly. Reattach

battery clips.

Using incorrect type of

Use true RMS reading meter.

voltmeter to test
output voltage.

Reason

Solution

Battery voltage below

Recharge or replace battery.

10.0 ± 0.5 volts.

Equipment being operated

Use a higher capacity inverter

draws too much power.

or do not use this equipment.

Inverter is too hot (thermal

Allow inverter to cool.

shutdown mode).

Check for adequate ventilation.

Reduce the load on the

inverter to rated continuous

power output

Unit may be defective.

See Warranty and call

Customer service at

1-888-231-4022.

Troubleshooting

PROBLEM: Low or No Output Voltage

PROBLEM: Red LED On

In Review

• Never attempt to operate the inverter from any other power source other than

a 12-volt battery.

• When connecting and using the inverter, make sure that the inverter is

positioned far away from any potential source of flammable fumes or gases.

• Make certain that the power consumption of the equipment you wish to

operate is compatible with the capacity of the inverter. Do not exceed

3000 watts in total power, or 1600 watts for each individual AC outlet.

• When attempting to operate battery chargers, monitor the temperature of the

battery charger for approximately 10 minutes. If the battery charger

becomes abnormally warm, disconnect it from the inverter immediately.

• Use only 30 amp spade type fuses for the inverter.
• When operating the inverter with an automobile or marine battery, start the

engine every 30 to 60 minutes and let it run for approximately 10 minutes to

recharge the battery.

• In the event of a continuous audible alarm or an automatic shut down of the

unit, turn the inverter OFF immediately. Do not turn the inverter ON again

until the source of the problem has been identified and corrected.

• To avoid battery drain, always disconnect the inverter when not in use.
• Do not expose the inverter to rain or moisture.
• Avoid placing the inverter near sources of heat or in direct sunlight.
• While in use, make sure that the inverter is properly ventilated.
• For best operating results, make sure the unit is placed on a flat surface.