Craftsman 919.15216 - Manual (Page 16)

16 - ENG
7. Using an adjustable wrench
remove the regulator manifold.
8. Apply pipe sealant to new
regulator manifold and assemble,
tighten with wrench.
9. Reapply pipe sealant to safety
valve.
10. Reassemble all components in
reverse order of removal. Make
sure to orient gauges to read
correctly and use wrenches to
tighten all components.
5. Remove pump mounting screws
securing pump (one on each side).
Pump Mounting Screw
6. Carefully slide pump from
brackets and out of the way.
Pump
shown
moved out
of the way
Regulator
Manifold
STORAGE
Before you store the air compressor,
make sure you do the following:
1. Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2. Drain water from air tank. See To
Drain Tank under Maintenance.
Water will condense
in the air tank. If
not drained, water will corrode and
weaken the air tank causing a risk of
air tank rupture.
3. Protect the electrical cord and air
hose from damage (such as being
stepped on or run over). Wind
them loosely around the compres-
sor handle.
4. Store the air compressor in a
clean and dry location.