Campbell Hausfeld PW1350 - Manual (Page 5)

32 Sp
Instrucciones de montaje y lista de piezas PW1350
Figure 6
Salida de agua
Entrada
de agua
Lavadora a
presión
Enchufe
GFCI
Manguera
de jardín
Pistola
Manguera de
alta presión
Interruptor de
encendido/apagado
(ON/OFF)
Lanza
Traba del gatillo
Adaptador
de pivote
Notas
the gun and push the lock from left to
right. Squeeze trigger to make sure the
trigger does not move. The safety trig-
ger lock should be locked at all times
when pressure washer is not in use.
5
www.chpower.com
Operating Instructions and Parts List PW1350
• Pressure washer is not meant to pump
hot water. NEVER connect it to a hot
water supply as it will significantly
reduce the life of the pump.
• NEVER store the pressure washer
outdoors or where it could freeze. The
pump will be seriously damaged.
• Release trigger when changing from
high to low pressure modes. Failure to
do so could result in damage
Keep hose away from
sharp objects. Bursting hoses may cause
injury. Examine hoses regularly and
replace if damaged. Do not attempt to
mend a damaged hose.
Garden Hose Connection
Instructions
1. Attach swivel adapter to pump water
inlet, if not already attached. Notice
the swivel adapter is marked with the
words pump and hose. Make sure to
connect pump side of adapter to pump
water inlet to prevent damage to the
threads.
2. Attach garden hose to swivel adapter
side marked hose.
3. The spray gun should be locked into
the "OFF" position by locating the safe-
ty trigger lock just above the trigger of
the gun. Activate the lock by holding
Figure 2 - Garden Hose Connection
Garden
Hose
Swivel
Adapter
Power Cord
1. Plug the power cord into a grounded
120V outlet and press the reset
button as shown in Figure 3.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 3 - Grounded plug/reset button