Coleman Denali 9790 - Manual (Page 8)

FUEL GAS TIP
Coleman® Fuel No Groove
Unleaded gasoline No Groove
Kerosene Groove
Coleman® 3250 Butane/Propane No Groove
Changing the Gas Tip 4
■ Turn the flame adjuster fully counter-clockwise to lower the clean-out
wire (Fig. 4).
■ Remove the impingement plate (Fig. 5).
■ Use the combination tool provided with the stove to replace the gas tip
(Fig. 6).
■ See chart above to match the fuel type with the correct gas tip.
■ Reinstall the impingement plate.
FIG. 7
Stove Set Up
5
■ Unfold stove by lifting legs out of
detents and rotating out until
legs snap into the open position
(Fig. 7). Place the stove on the
reflector disc.
NOTE: The reflector disc and windscreen are not illustrated in
the set up instructions. This is so the features of the stove may
be clearly visible and identified. Read about the reflector disc
and windscreen in Sections 1 and 17.
English-7
NOTE: Make sure the hole in the gas tip easily slips over the clean-out wire. If
the wire bumps the gas tip, damage to the clean-out wire may occur.
FIG. 4 FIG. 6 FIG. 5
Lower the
clean-out wire.
No
Groove
Groove
FIG. 3