Installation, Setup, Operation – Philips Funda de transporte User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
Setup
Open the Battery compartment located
on the inside door of the Speaker Case.
Install 2 AAA batteries in the battery
compartment following the polarity
markings.
Operation
After installing batteries into the compartment,
turn on the power switch. Insert the 3.5
mm plug from the Speaker Case into the
headphone jack on your Audio device. Make
sure that the Volume on your Audio Device
is set to an acceptable level. Press the play
button on the Audio Device to start playback
over the speaker. For your convenience you
can place your portable Audio player in the
pouch directly opposite the speaker.
Operational tips:
Turn the unit off when the Speaker Case is
not in use, to avoid reducing battery life.
Change the batteries when the power LED
becomes weak or if there is no sound or if
the sound quality is poor.
Distortion may occur at maximum Volume
levels, under these conditions reducing the
volume level should improve sound quality.
4