Creda Cooker - Manual (Page 19)

USING THE CERAMIC HOB
OPERATION WHEN USING THE CERAMIC HOB
Step 1 Place the saucepan centrally on the required hob element.
Step 2 Turn the required hotplate control knob to the required setting.
Set to:- 1-6 Single Circuit Hotplate
1-4 Twin Circuit Hotplate (Clockwise)
1-4 Inner Circuit (Anti-clockwise)
1=Low, 6 or 4=High
Step 3 After use, turn control(s) to their OFF (O) position.
IMPORTANT
1. Always clean up any spillage immediately with a clean cloth or a paper
towel to avoid unnecessary damage to the hob. Extreme care should be
taken to avoid steam burns and hot surfaces when cleaning spillage from
the hob.
2. When cooking food that contains sugar (most food) or syrup, use a utensil
which is large enough to prevent boil over or spillage. Sugar spillage will
permanently damage the hob and therefore should be cleaned off
with care immediately. If sugar spillage has occurred, remove it as long
as it is still hot with a metal safety razor scraper. This will avoid any
damage. NEVER LET IT COOL BEFORE REMOVING.
3. Always ensure that the base of the utensil is dry before placing on the
ceramic hob.
19
CAUTION: IF ANY CRACK IN SURFACE BECOMES VISIBLE,
DISCONNECT THE APPLIANCE IMMEDIATELY FROM THE SUPPLY.
DO NOT allow young children near to the appliance when the hob is in use
as the surfaces get extremely hot.
HOB SETTING CONTROLS (A)
TIMER
Under no circumstances should the hob be used with aluminium foil in contact with
the hob surface.
The boiling plates are located beneath the circular cooking areas.
WARNING: Extreme caution should be used when cleaning the hot
hob.