Clarion CZ500 - Manual (Page 12)

English
Français
English
Italiano
English
Español
English
English
English
12
Select tuner as playing source
Press the [SRC] button once or more to enter
radio mode.
Select one radio band
Press the [BAND] button on the panel or
[BND] button on the remote control to select
one radio band among FM1, FM2, FM3, AM.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [ ] / [ ] button on the front
panel or the remote control to tune in a higher/
lower station.
Auto tuning
Press and hold the [ ] / [ ] button on
the front panel or the remote control to seek a
higher/lower station.
To stop searching, repeat the operation above
or press other buttons having radio functions.
Note:
When a station is received, searching stops
and the station is played.
If the unit receives a stereo broadcast, the
indicator light of stereo ‘ST’ on the LCD
display lights.
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the [PS/AS] (2 sec.) button to
start automatic station search.
To stop auto store, press other buttons having
radio functions.
Note:
1. After auto store, the previous stored
stations will be overwritten.
2. The unit has four bands: FM1, FM2,
FM3 and AM. FM3 and AM can store by
AS function. Each bands can store six
stations, CZ500 can store 24 stations in
total.
Manual store
While tuned into a desired radio station, press
and hold number button 1–6 to store it in the
memory.
Radio Operations
Recall the stored stations
Press one numeric button among 1 to 6 on
the panel or the remote control to select the
corresponding stored station.
Local seeking
When LOCAL seeking is on, only those
radio stations with strong radio signal can be
received.
Press and hold the [D] button on the
front panel, then press the [ ] button
repeatedly until LO or DX displays on the
screen, and rotate the knob to select Local or
Distant mode.
Note:
The number of radio stations that can be
received will decrease after the local seeking
mode is on.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station in
memory.
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the [PS/AS] button again to continue
receiving that station.
Note:
Be careful not to press and hold the [PS/AS]
button for two seconds or longer, otherwise
the auto store function is engaged and the
unit starts storing stations.