CDA RC 9620 - Manual (Page 24)

24
Care and Maintenance
Important:
As a safety measure, before you start cleaning the cooker be sure to disconnect it from the mains supply.
– Do not use cleaning products with a chlorine or acidic base.
– Do not use a steam cleaner because the moisture can get into the appliance thus make it
unsafe.
– The use of suitable protective clothing/gloves is recommended when handling or cleaning
of this appliance.
WARNING
When correctly installed, your product meets all safety requirements laid down for this type of product
category.
However special care should be taken around the rear or the underneath of the appliance as these areas are
not designed or intended to be touched and may contain sharp or rough edges, that may cause injury.
Spillage
Any spillage should be dealt with as soon as possible to prevent it becoming burnt on.
Vitroceramic Cooking Hob
- See page 13.
Enamelled Parts
All the enamelled parts must be cleaned with a sponge and soapy water only or other non-abrasive
products.
Dry preferably with a micro fibre or soft cloth.
Stainless Steel, Aluminium, Painted Parts and Silk-screen Printed Surfaces
Clean using an appropriate product. Always dry thoroughly.
Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abrasion. You are advised
to use a soft cloth and neutral soap.
CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably
damage the surface.
Changing the Oven Light
1. Disconnect the electrical power supply (for example, by switching off the main power switch).
2. Unscrew the light cover
3. Fit a new bulb.
4. Refit the cover.
Note:
Use only bulbs designed to resist up to 300°C with the following characteristics: 230 V, type E14 and same
power (check watt power as stamped in the bulb itself) of the replaced bulb.