Cortelco Caller ID Type II 9125 - Manual (Page 17)

17
SPEED DIAL
The 9125 can store up to 20 names and numbers in the memory buttons. Two names and
numbers can be programmed in each button.
STORE NEW NUMBERS
Entering a number
1. Place the phone on hook.
2. Enter the number to be stored.
3. Press and hold the memory button or press SHIFT and then press and hold the
memory button until the last digit of the number blinks.
4. Press SAVE.
5. The cursor will blink in the name field below the number.
6. Use the keypad to enter the name or press SAVE to store with no name.
7. If a name was entered, press SAVE.
8. The display shows “SAVE OK.”
Storing a Caller ID Record or Dialed Call
1. Place the phone on hook.
2. Use the or key to display the desired number from incoming calls or dialed calls.
3. Press and hold the memory button or press SHIFT and then press and hold the
memory button until the last digit of the number blinks.
4. Press SAVE.
5. The cursor will blink in the name field below the number.
6. Use the keypad to edit the name or press SAVE to store as is.
7. If the name was edited, press SAVE.
8. The display shows “SAVE OK.”
DIAL A NUMBER FROM MEMORY
Go off hook, and press the memory button. The number will be dialed out. To dial the
second number stored in a location, go off hook, press SHIFT and then press the
memory button.
REVIEW THE CONTENTS OF A MEMORY BUTTON
While on hook, press the memory button or press SHIFT and then press the memory
button. The display will show the memory contents. To dial this number, go off hook.
SPEAKER BUTTON
This button controls the speakerphone. Press once to activate the speakerphone. Press
again to deactivate.