Jeep 2012 Liberty User Manual

Page 31

To Enter Remote Start Mode

Press and release the REMOTE START button
on the RKE transmitter twice within five sec-
onds. The parking lights will flash and the horn
will chirp twice (if programmed). Then, the

engine will start and the vehicle will remain in the
Remote Start mode for a 15-minute cycle.

NOTE:

• If your power door locks were unlocked, Remote Start

will automatically lock the doors.

• If an engine fault is present or fuel level is low, the

vehicle will start and then shut down in 10 seconds.

• For security, power window operation and sunroof or

Sky Slider

௡ operation (if equipped) is disabled when

the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two

15-minute cycles) with the RKE transmitter. However,
the ignition switch must be cycled to the ON/RUN
position before you can repeat the start sequence for a
third cycle.

To Exit Remote Start Mode Without Driving The
Vehicle
Press and release the REMOTE START button one time or
allow the engine to run for the entire 15-minute cycle.

NOTE:

To avoid unintentional shut downs, the system

will disable the one-time press of the REMOTE START
button for two seconds after receiving a valid Remote
Start request.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE