Jeep 2012 Liberty - Manual (Page 192)

to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink
௡ button you wish to program
while keeping the HomeLink ௡ indicator light in view.
3. Continue to press and hold the HomeLink ௡ button,
while you press and release (“cycle”), your hand-held
transmitter every two seconds until HomeLink
௡ has
successfully accepted the frequency signal. The indicator
light will flash slowly and then rapidly when fully
trained.
4. Watch for the HomeLink
௡ indicator to change flash
rates. When it changes, it is programmed. It may take up
to 30 seconds or longer in rare cases. The garage door
may open and close while you are programming.
5. Press and hold the programmed HomeLink ௡ button
and observe the indicator light.
• If the indicator light stays on constantly, program-
ming is complete and the garage door/device
should activate when the HomeLink
௡ button is
pressed.
• To program the two remaining HomeLink௡ buttons,
repeat each step for each remaining button. DO
NOT erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
190 UNDERSTANDING THE FEATURES OF YOUR VEHICLE