Jaypro sports, Floor plate assembly-floating floor, fp-100, List of materials – Jaypro Sports FP-100 User Manual
Page 3: 1fac-101bcover plate assembly 1, Assembly instructions, Tools required: hammer drill, Notice, Please read instructions in

JAYPRO SPORTS
FLOOR PLATE ASSEMBLY-FLOATING FLOOR, FP-100
LIST OF MATERIALS
PIECE NO. PART
NO. DESCRIPTION
QTY.
1
FAC-101B
COVER PLATE ASSEMBLY
1
2
HS5122
#7-1” FLAT HEAD WOOD SCREW
4
3
HS5062
HEX HEAD BOLT ½”-13 x 5”
1
4
HEX HEAD NUT ½”-13
1
6
FLOOR ANCHOR ASSEMBLY
1
7
EYEBOLT (LIFTING RING) ¼”-20
1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Hammer Drill
1 3/8” Masonry Drill Bit
Mixing Container & Water
Small Vacuum Cleaner
Stiff Circular Brush (Bottle Brush)
Putty
Knife
Or
Scrapper
Rag Or Other Absorbent Material
Regular
Power
Drill
2 1/8” Wood Hole Saw
7/64”
Drill
Bit
Router
Screwdriver With Phillips Blade
½”
Bolt
¾ lb. (Approx) Non Shrink Anchoring Cement
NOTICE
The fp-100 floor plate assembly is manufactured with a removable center section which can be replaced
in the event that the internal threads are damaged. Upon original installation of the floor plates or
replacement of the threaded sections, be sure that the replacement threaded sections are installed very
tightly using a thread-locking sealant to prevent easy removal or tampering.
PLEASE READ INSTRUCTIONS IN
THEIR ENTIRETY BEFORE BEGINNING INSTALLATION
1)
Locate and mark the center locations of the floor plates using the layout diagram in the equipment
instruction sheet. Re-check all the center locations for accuracy before installing the floor plates.
2)
Using the 2 1/8” wood hole saw, drill a hole in the wood floor and the wood sub-floor down to the
concrete base as shown in the wood floor detail.
3)
Screw the ½” bolt with the nut into the bottom of the floor plate. Adjust the bolts so it will reach ½” x
¼” from the bottom of the hole when the floor plate is in place. Tighten the nut against the floor plate
bottom to lock the bolt into place. In some cases the bolt supplied with the fp-100 unit will not reach to